|
M000
Error when trying to run the CSF program.
Note: Whenever you see A:, B:, C: or D:
within this text, A: and B: represent your
possible floppy drives within your computer
and C: and D: represent your possible hard
disks within your computer. If you only
have one (1) floppy drive, it is the first
drive in your computer and considered A:
- your hard disk would then be considered
C:.
A: and B: can be switched in any example
below to meet the needs of your computer
system.
C: and D: can be switched in any example
below to meet the needs of your computer
system.
----------
M000 Error
----------
The M000 error is caused because the protection
device could not be placed onto your hard
drive. Here are the instructions for resolving
the error.
1. Put disk 1 (Saumrau) into A or B
2. Type CSFCHCK D: (from an A or
B prompt)
You want this to return with Error (24)
If not.....
2a. Type SCPBAT R D: A: CSFWIN (From
an A or B prompt) - then
try #2 again until you get the ERROR 24.
3. Type SCPBAT I A: D: CSFWIN (from
an A or B prompt) to install
the new protection device.
4. Type CSFCHCK D: to verify that
the protection device is now on
your D drive. This should return a "Remaining
Installs 000" - if so, you
are OK and ready to go.
|
