|
How
to check and modify the protection device.
Note: Whenever you see A:, B:, C: or D: within this
text, A: and B: represent your possible floppy drives
within your computer and C: and D: represent your
possible hard disks within your computer. If you only
have one (1) floppy drive, it is the first drive in
your computer and considered A: - your hard disk would
then be considered C:.
A: and B: can be switched in any example below to
meet the needs of your computer system.
C: and D: can be switched in any example below to
meet the needs of your computer system.
----------------------
Checking the installs on the program disks and your
hard drive.
----------------------
To check the remaining installs on the program disks
and your hard drive we need to do the following:
Put disk #1 into drive A or B
Go to an A or B prompt
type CSFCHCK A: or B:
This should return with "Remaining Installs (000)"
or (001) or (002).
If it returns (000), you are out if installs and will
need to reset
your program disks.
next...
From an A: or B: prompt
type CSFCHCK C: or D:
This should return with "Remaining Installs (000)"
if there is an install
left on the hard drive.
- or -
If it returns ERROR 24, there are no installs on the
hard drive.
|
